Shahabad Stone Flooring

Shahabad stones is a type of stone and most commonly used for sculpture and as a building material. Shahabad stones are a very good export quality of stone from India. It has a beautiful look that’s why you can use it in several forms such as countertop, table top, wall cladding, in flooring designs, kitchen top, marble floor boards and many others.

PRODUCT FEATURES:

● Adds real estate value

● Affordable

● Hard and durable

● Cost effective.

● Highly durable.

● Acid resistant.

● Smooth finishing and shining.

● Chemical resistance

● Stain resistance

● Good strength and withstand high temperature.

● These are natural and eco-friendly.

● Extremely durable

● Easy to maintain & easy to clean.

INSTALLATION METHOD:

1. Step 1 – Prepare the Surface

Before installing the tiles, the floor should then be cleaned using a special cleaner specifically designed for that type of subfloor. Follow the instructions that come with the cleaning product for further advice.

The surface will then need to be perfectly level. To achieve this, you can purchase a compound which levels by itself. Follow the manufacturer’s instructions to get the best results. This compound will need to thoroughly cover the subfloor. It will then need to be spread over the surface evenly and then left to dry for approximately 24 hours.

1. Step 2 – Find the Center of the Room

You will need to find the exact center of the room as this will act as a reference point when you start laying the tiles. To do this, run lines diagonally across the room from opposite corners to form a cross. The point where the lines meet will mark the center of the room. Mark two more lines passing through the cross and connect the centers of the opposite walls. If your room is not a four-sided shape, then work with each section separately.

1. Step 3 – Determine the Layout of the Shahabad Tiles

Take extra care to determine the exact layout of the tiles because there is no going back at a later time. To do this, place a row of tile along each line and find the best position for the layout. You should design the layout so that it uses as many uncut tiles as possible. Mark the determined positions using the chalk.

1. Step 4 – Placing the Shahabad Tiles

Mix the mortar as directed by the manufacturer’s instructions. Start from the center of the room with a patch of mortar roughly four foot square. Apply the mortar evenly using a trowel held at a 45 degree angle. Place the tiles onto this surface, twisting them slightly as you press them down to get a better grip. Use two tile spacers in each gap between tiles to ensure that the gaps are kept in accurately equal width. For tiles which are not completely level, tap them in place with a rubber mallet. Continue to use a spirit level over every three or four tiles that you lay to ensure that the surface is even. Some tiles will also need to be cut so that they fit at the edges of the room. Use a special tile cutter to do this.

1. Step 5 – Sealing and Grouting the Shahabad Tiles

When the tiles have been left overnight to set, place a layer of sealant over the surface. This needs to be evenly applied over the tiled area. Two hours after, apply grout between the tiles and remove the tile spacers. Allow this to dry before giving the surface a final clean. The surface should be allowed a couple of weeks to fully set.

INSTALLATION MATERIALS:

⮚ Notched Trowels

⮚ Screwdriver

⮚ Hammer

⮚ Floor leveling compound

⮚ Spackling compound

⮚ 1/2-inch cement fiberboard

⮚ Straightedge tool

⮚ Utility knife

⮚ Thinset mortar

⮚ Notched trowel

⮚ Carpenter’s level

⮚ Fiberglass mesh tape

⮚ Chalk line

⮚ Carpenter’s angle

⮚ Spacers

⮚ Wet saw with diamond blade

⮚ Grout

⮚ Grout float

⮚ Sponge

⮚ Soft cloth

⮚ Sealer