Panel Blinds

Panel blinds are stylish and practical. The panel blind provides an innovative shading solution for larger windows and patio doors that looks fabulous in both contemporary and traditional settings. It also looks stunning as a room divider that can be used to great effect in creating new living spaces within a modern home. When open, the panels stack neatly behind one another allowing maximum light to enter the room. Sliding the blind into the closed position creates a unique fabric screen that provides light control and privacy. This type of blind is built from thin fabric in wide sections that hang vertically. Unlike vertical blinds, these blinds typically only have four wider sections instead of many thin slats

PRODUCT FEATURES:-

• Practical and stylish with control options- including motorized.
• Filter light to achieve privacy and sun protection.
• Versatile for different window and doors.
• Child safe wand operation available with no cords or chains.
• Slide open and close.
• Economical.

ACCESSORIES:-

▪ Valance

▪ Head rail

▪ Valance clip

▪ Bracket

▪ Nut and bolt

▪ Extension Bracket

▪ Screws

▪ Star washer

▪ Tilt rod

▪ Master carrier

▪ Spacer strap

▪ Stem

▪ Retainer clip

▪ Tilt Chain

▪ Draw cord

▪ Wand tilt control

▪ Vane/ Slat

INSTALLATION METHOD:-

1. From the point at the bottom of your window where your blinds will hang, measure up to the top of your window the length of the blinds you have ordered. Make a mark at the top of the measurement and center your head rail on the mark.
2. Use a pencil to make a mark 3 inches in from each end of the head rail.
3. Align the top of your left bracket along the inside of the pencil line and fasten to the wall with the supplied screws. Repeat on the right side, as well as for any additional brackets. Make sure the brackets are aligned and level.
4. Hook the front of your head rail into the brackets and push up on the backside until it snaps into place.
5. To install the vanes or louvers, pull the cord to space the vane stems evenly, then use the chain to rotate until the openings are facing you.
6. Attach the first vane by gently sliding it up into the plastic stem until it snaps into place. Repeat this process until all vanes are attached.
7. Install your safety bracket to keep the cord or chain taut. Place the bracket near the outside bottom of the window frame where it will not interfere with the operation of your vertical blinds.
8. Insert the valance ends into the corners of the valance and attach to the front. Attach the included valance clips onto the head rail and slide the valance onto the clips.
9. Test your new blinds. Use the pull cord to slowly raise and lower your blinds, and tilt your slats by either adjusting the tilt cord or rotating the wand.