Stone Veneer Wall Panels

Product Image

Application Areas

Product Features

Stone veneer is a thin layer of any stone used as decorative facing material that is not meant to be load bearing. Stone cladding is a Stone veneer, or simulated stone, applied to a building or other structure made of a material other than stone.

PRODUCT FEATURES:

  • Eco Friendly
  • Wear Resistance
  • Flame Retardant
  • Anti-Bacterial Functions
  • Easy to Clean

Product Information

PURPOSE:-

  • It gives decorative look to the walls
  • Enhances beauty of the area

APPLICATION AREAS:-

  • Commercial
  • Hospitals
  • Dining room walls
  • Office spaces
  • Exterior elevations
  • Entryways
  • Living room walls

Technical Information

ACCESSORIES:

  • Razor Knife
  • Hammer
  • Screw Gun
  • Tape Measure
  • Pencil
  • Masonry Saw
  • Level/String Line
  • Rubber Mallet
  • Trowel
  • Grout Bag
  • Joint Slicking Tool
  • Brush

INSTALLATION METHOD:

  1. Start by ensuring the substrate is suitable to receive the stone veneer. Drywall is not a suitable substrate to install stone veneer on. The substrate should be level, plumb, and free of any dirt, debris, or contaminants.
  2. Select and mix a thin set that meets or exceeds ANSI 118.4 and 118.11 standards. Mix thin set according to the manufacturer's recommendation and only mix up enough that you'll use in about 15-20 minutes to keep it workable.
  3. Chalk or draw a level line up off the floor since many floors aren't level starting point and use that as a starting point, making sure to trim or shim up the first row to level.
  4. Apply thin set directly to the wall, spread, and notch using a 1/2" square notch, and lightly spread thin set over the back of each panel to assure full coverage.
  5. Set and twist each panel onto the wall to ensure a good bond with the thin set. Work one course at a time making sure to stagger where vertical seams fall from one course to the next, and check your level every few panels to ensure the installation stays tight. Use tile spacers as necessary to keep rows level over slightly uneven substrates.
  6. Keep a sponge and bucket of water handy to clean off any thin set that finds its way onto the face of the stone before it dries.
  7. Sealing is not necessary for interior wall applications, but can be used to enhance the finish of the stone. Only use water based penetrating sealers and tests all sealers on a sample piece of stone to confirm the effect.
  8. Reference our detailed installation guide for additional recommendations and detail on installing stacked stone on an interior wall.

Maintenance and Warranty

MAINTENANCE:-

  • Dust regularly
  • Keep away from sunlight
  • Clean off stains and splatters immediately
  • Keep your panels dry
  • Rinse the stone/brick with water to remove loose debris.
  • Using a circular motion scrub the dirtiest areas first using a medium bristle brush.
  • Rinse the cleaned area thoroughly, removing all detergent and suds.

WARRANTY: 1 year for color fade

SUB-BASE REQUIREMENTS: DRY, LEVELED, NO DIRT OR GRITS, NO CRACKS, FIRM

MEASUREMENT METHOD AND UNIT:

  • You need to measure the area you are covering.
  • Measuring the area is fairly easy if you have a square or rectangular wall, as you can easily measure two sides to obtain the square foot.
  • AREA=LENGTH X BREADTH ,Consider 5% for wastage

Shade Card : Available on Request

Videos : Available on Request